2025 Landoll 845-48-AG

The heavy haul requirement was carefully considered during the product development of the 845-AG resulting in a 45-ton capacity trailer that comes standard with a Heavy Duty Gooseneck with provisions for a 36” Flip extension. Haul More with Landoll Hauloll Detachable The new 845-AG Hauloll is designed to move today's and tomorrow’s heaviest equipment. The 845-AG’s 45-ton capacity is matched to handle even the heaviest of the field-ready tractors and choppers in production today. The heavy haul requirement was carefully considered during the product development of the 845E-AG resulting in a trailer that comes standard with a Heavy Duty Gooseneck with provisions for a 36” Flip extension. Built For the Heavy Haul – Ag, Construction, Forklifts, and More The 845-AG capacity comes in at 45 tons (90,000 lbs within 16’ and 80,000 lbs within 12’), and a 19-1/4” loaded deck height keeps the center of gravity lower than most detachable trailers. This trailer is built with Heavy Haul aluminum pullouts that are 30% stronger than the 835 pullouts and extend out to 13’ wide on 6” increments. Pulled out to the proper width and planked, these over widths are designed to handle big wheel loaders and some tracking equipment. Enlarged lift cylinders with a 150,000 lb lift capacity and gooseneck flip brackets for 36” flip overextension round out the heavy haul features on the 845-AG. The heavy haul load carrier allows the driver to match the needed ground clearance in one of the 7-ride height positions to choose from. Raising the Bar on GVWR Most 2-axle base trailers run out of GVWR to legally permit many heavier loads. The Landoll 845-AG tops out at 116,500 lbs / 51,076 KG GVWR allowing for a full 90,000 lbs of payload. The trailer equipped with the gooseneck extension and the third flip axle will scale even the toughest AG tractors. Now as always, each state DOT will control the exact weight you can transport on their individual highways. Regen-Hoss Hydraulics Not only is the 845-AG built for heavy haul Ag, it comes standard with REGEN-HOSS hydraulics, the new hydraulic -regeneration valve system with Rexroth valve rated at 2500 PSI and 20GPM. That is a significant increase in hydraulic speed, decreasing the amount of time it takes to load equipment.